Hardware Specifications |
QSFP28 Slots |
4, each supports native 100/40 Gigabit Ethernet and 4 x 10 Gigabit Ethernet modes |
SFP+ Slots |
24 10GBASE-SR/LR SFP+ interfaces |
Compatible with 1000BASE-SX/LX/BX SFP transceiver |
MGMT |
1 x 10/100/1000Base-T RJ45 port |
Console |
1 x RJ45-to-DB9 serial port (9600, 8, N, 1) |
USB |
1 x USB 2.0 |
Switch Architecture |
Store-and-forward |
Switch Capacity |
800Gbps/non-blocking |
Switch Throughput |
960Mpps |
Address Table |
32K MAC address table with auto learning function |
Shared Data Buffer |
4MB |
Flow Control |
Back pressure for half duplex |
IEEE 802.3x pause frame for full duplex |
Jumbo Frame |
9KB |
LED Indicator |
System: |
PWR, SYS |
Ports: |
40G/100G QSFP Port: LNK/ACT |
Dimensions (W x D x H) |
442.5 x 364 x 44 mm, 1U height |
Weight |
5990g |
Power Consumption |
75 watts/210 BTU (maximum) |
Power Requirements |
AC 100~240V, 50/60Hz |
Fan |
4 |
Management Function |
System Configuration |
Console; Telnet; SSH; SSL; Web browser; SNMP v1, v2c and v3 |
Management |
Supports both IPv4 and IPv6 Protocols |
Supports the user IP security inspection for IPv4/IPv6 SNMP |
Supports MIB and TRAP |
Supports IPv4/IPv6 TFTP |
Supports IPv4/IPv6 NTP |
Supports RMON 1, 2, 3, 9 groups |
Supports the RADIUS authentication for IPv4/IPv6 Telnet user name and password |
Supports IPv4/IPv6 SSH and SSL |
The right configuration for users to adopt RADIUS server’s shell management |
Supports CLI, console, Telnet |
Supports SNMPv1, v2c and v3 |
Supports Security IP safety net management function: avoid unlawful landing at non-restrictive area |
Supports syslog server for IPv4 and IPv6 |
Supports TACACS+ |
Layer 3 Function |
Routing Protocol |
Static routing, RIP and OSPF |
Routing Table |
16K |
DHCP |
DHCP client |
DHCP server, default route |
DHCP relay |
VRRP |
Configure VRRP in interface VLAN; |
VRRP priority; |
VRRP standby; |
VRRP track |
Load Balancing |
Use of equivalent routing, the correct load balancing function (by flow) |
Layer 2 Function |
Port Configuration |
Port disable/enable |
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection |
Flow control disable/enable |
Bandwidth control on each port |
Port loopback detect |
Port Status |
Display each port’s speed duplex mode, link status, flow control status and |
auto negotiation status |
VLAN |
802.1Q tag-based VLAN, up to 4K VLAN entries |
802.1ad Q-in-Q (VLAN stacking) |
GVRP for VLAN management |
Private VLAN Edge (PVE) supported |
Protocol-based VLAN |
MAC-based VLAN |
IP subnet VLAN |
Bandwidth Control |
TX/RX/both |
Link Aggregation |
IEEE 802.3ad LACP/static trunk |
Supports 32 groups with 8 ports per trunk group |
QoS |
8 priority queues on all switch ports |
Supports strict priority and Weighted Round Robin (WRR) CoS policies |
Traffic classification: |
– IEEE 802.1p CoS/ToS |
– IPv4/IPv6 DSCP |
– Port-based WRR |
Multicast |
IGMP v1/v2/v3 snooping |
Querier mode support |
MLD v1/v2 snooping |
Querier mode support |
Multicast VLAN Register (MVR) |
Access Control List |
Supports Standard and Expanded ACL |
IP-based ACL/MAC-based ACL |
Time-based ACL |
Up to 1K entries |
Bandwidth Control |
At least 64Kbps stream |
Security |
Port isolation |
Supports IP + MAC + port binding |
Identification and filtering of L2/L3/L4 based ACL |
Defend against DOS or TCP attacks |
Suppression of broadcast, multicast and unknown unicast packet |
DHCP Snooping, DHCP Option 82 |
Command line authority control based on user levels |
Authentication |
IEEE 802.1x port-based network access control |
AAA authentication: TACACS+ and IPv4/IPv6 over RADIUS |
SNMP MIBs |
RFC 1213 MIB-II |
RFC 1215 Internet Engineering Task Force |
RFC 1271 RMON |
RFC 1354 IP-Forwarding MIB |
RFC 1493 Bridge MIB |
RFC 1643 Ether-like MIB |
RFC 1907 SNMPv2 |
RFC 2011 IP/ICMP MIB |
RFC 2012 TCP MIB |
RFC 2013 UDP MIB |
RFC 2096 IP forward MIB |
RFC 2233 if MIB |
RFC 2452 TCP6 MIB |
RFC 2454 UDP6 MIB |
RFC 2465 IPv6 MIB |
RFC 2466 ICMP6 MIB |
RFC 2573 SNMPv3 notification |
RFC 2574 SNMPv3 VACM |
RFC 2674 Bridge MIB Extensions |
Standard Conformance |
Regulatory Compliance |
FCC Part 15 Class A, CE |
Standards Compliance |
IEEE 802.3z Gigabit 1000BASE-SX/LX |
IEEE 802.3ae 10Gb/s Ethernet |
IEEE 802.3x flow control and back pressure |
IEEE 802.3ad port trunk with LACP |
IEEE 802.1D Spanning Tree Protocol |
IEEE 802.1w Rapid Spanning Tree Protocol |
IEEE 802.1s Multiple Spanning Tree Protocol |
IEEE 802.1p Class of Service |
IEEE 802.1Q VLAN tagging |
IEEE 802.1X port authentication network control |
IEEE 802.1ab LLDP |
RFC 768 UDP |
RFC 793 TFTP |
RFC 791 IP |
RFC 792 ICMP |
RFC 2068 HTTP |
RFC 1112 IGMP v1 |
RFC 2236 IGMP v2 |
RFC 3376 IGMP v3 |
RFC 2710 MLD v1 |
FRC 3810 MLD v2 |
RFC 2328 OSPF v2 |
RFC 1058 RIP v1 |
RFC 2453 RIP v2 |
Environment |
Operating |
Temperature: 0 ~ 50 degrees C (24 x 10G SFP+ + 2 x QSFP28) |
Relative Humidity: 10 ~ 85% (non-condensing) |
Storage |
Temperature: -40 ~ 80 degrees C |
Relative Humidity: 5 ~ 95% (non-condensing) |